
Every other competitive Senate race from this cycle has been called. Alaska’s has not, and the reason is not a mystery or a legal fight this time. It comes down to a scheduled, rules based process that Alaska has used since 2020 and that voters just reaffirmed this very election. Here is what actually happens, step by step.
1. The threshold that decides whether tabulation even happens
A candidate only needs to clear one bar to win outright: more than half of all first choice votes. As of this week, Democrat Mary Peltola sat at 49.98 percent, with Republican incumbent Dan Sullivan at 45.93 percent, a few hundredths of a point short of the outright majority that would end the race immediately.
2. How the ballot got this shape in the first place
Alaska replaced its old party primary system in 2020 with one that sends the four leading candidates from a single nonpartisan primary straight to the general election ballot, where voters can then rank their choices instead of picking just one. Alaskans actually voted on whether to keep this system again this cycle, rejecting a measure that would have repealed it, so this week’s tabulation is happening under a system voters just chose to keep rather than one imposed on them.
3. What the tabulation itself actually does
Officials run tabulation in rounds, starting only after the final count of ballots, which under state rules begins on the fifteenth day after the election, landing this year on Wednesday. If nobody cleared a majority in the first round, officials eliminate whichever candidate finished last and look at every one of that candidate’s ballots to see who those voters ranked next. Those votes get added to the remaining candidates accordingly, and the process repeats, eliminating the last place finisher each round, until one candidate holds more than half the vote still in play.
4. Why this particular race may resolve in a single round
With a third candidate, Daniel J. Sullivan Jr., pulling only a small share of the vote, this race likely needs just one elimination round rather than several. Whoever his voters ranked second becomes the decisive variable, which is part of why his candidacy drew so much legal attention earlier this cycle.
5. What else is riding on the same count
Alaska’s U.S. House race between Republican incumbent Nick Begich and independent Bill Hill also sits below a first choice majority and may go through its own tabulation the same week, while the governor’s race was already decided outright after Democrat Jonathan Kreiss Tomkins cleared 50 percent on his own.
6. What happens after the tabulation runs
Results from tabulation are considered unofficial until Alaska’s State Review Board certifies them, which is scheduled for later this month. Certification does not close the door on a legal challenge entirely, but as this cycle’s earlier fights over this very race showed, there is no automatic recount waiting on the other side of a close ranked choice result either.
Why this matters to voters
A process that takes two weeks longer than most states’ counts can look chaotic from the outside, but Alaska’s tabulation is about as transparent as vote counting gets: the rules, the date, and the method were set long before a single ballot was cast, and voters had the chance to scrap the whole system this very year and chose not to. That is a meaningfully different kind of uncertainty than a race tied up in lawsuits or stuck behind a missing recount law.
References
Alaska Division of Elections, Election Essentials
Yahoo News, What Alaskans can expect as election officials tabulate ranked choice results
- What Actually Happens at Alaska’s Ranked Choice Tabulation This Week - November 17, 2026
- Why Alaska’s Senate Race Still Isn’t Decided, and Why There Were Two Dan Sullivans on the Ballot - November 10, 2026
- France’s Budget Standoff Just Escalated. Here Is How We Got to This Week - October 26, 2026
